If you use Ethernet to connect your devices, you understand what an essential it is to have your network constantly accessible. If another Ethernet crashes, your businesses may come to a complete halt. Assessing that your device has an Ethernet link is also the first step in configuring the network which is achieved by manually inspecting the cables for splits which loose links, as well as examining the network settings of your device can scan for the main cause of the problem. You might also need to get a new ethernet converter if yours is worn out and outdated. Follow the steps below to figure out the ethernet connection problem you have.

Ipconfig

To access Command Prompt, click the Windows Start key, type “cmd.exe” into the input space and push “Enter.” Type “ipconfig” excluding the quotation marks on the command, and click “Enter.” Navigate through the findings to see a line reading “Ethernet adapter Local Area Link.” If the device has an Ethernet connection, the connection would be mentioned in the entry. However, if there is an entry where it reads “Disconnected Devices,” the device may have an Ethernet socket, but it is not connected to the ethernet cables itself.

Ethernet Crossover Cable vs Ethernet LAN Cable – Router Switch Blog

Manual Inspection

Test that an ethernet cable plugged into the port on the back of the device is wired into the right slot. The Ethernet device can have the same device with three to 4 sockets. Such ports appear identical but are somewhat bigger than mobile jacks. Place the connector tightly into the gap on the end of the Ethernet cord. Push the plug all the deep into the outlet before you hear that sound of something connected.

Ethernet Card

Search the rear of its Ethernet card for status indicators. A constant green light on many of these Ethernet adapters indicates the computer’s Ethernet link is working and linked to a legitimate port or socket at the opposite side. The card might also slightly pop out from the original slot which will also be a problem.Network interface controller - Wikipedia

The Main Source

Trace your computer’s Ethernet cable to the place where it ends — like a gateway, modem, or switch — and test the system’s status lights. A green led signal normally implies a successful contact, whereas a blinking green light, or yellow light, suggests an issue. For detailed details about the status signals read or contact suppliers and the documents on your machine.

Ethernet Monitoring Tool

Try to verify the Ethernet cables using an Ethernet diagnostic monitoring tool. Your monitor and system on the other end may be good and provide the right Ethernet transmitting signals, but if the cable is wrong, the data may not be transmitted. Ethernet diagnostic testing tools work by transmitting test signals over the Ethernet cable. Plug the Ethernet cable into the tester, obey directions from the supplier, and run the diagnostic checks. A bad result means the Ethernet cable is defective, which can be repaired. If the cable falls in, the issue may be either the computer’s Ethernet network card or the system on the other end.